WS TuneLabSvenska

Bass reflex port sizing – area, length and rounded ends

Understand physical port length, end correction and rounded openings in WS TuneLab, including automatic and manual length modes.

Physical and acoustic lengths differ

Physical length describes the duct you build. The calculation also accounts for an estimated end correction and duct geometry. A length value alone is not a recipe: net volume, area and outlet conditions must belong to the same design.

Check the complete air path

Straight ducts, bends and branched T-ports have different geometries. A symmetric T-port divides flow between two branches. Check both outlets, wall clearance and the actual clear passage area. WS TuneLab displays the construction and identifies geometric conflicts. Its T-port acoustic model remains preliminary.

What does rounding the port ends do?

Select the radius and inner, outer or both ends for supported slot ports. The 3D geometry shows removed material, and the geometrically calculated air mass changes. The radius must fit the material and remain clear of adjoining bends and inserts. Custom workshop ports are not covered by this rounding operation.

Does the duct length change?

Supported automatically sized designs recalculate length toward the selected tuning. A manually entered physical length remains fixed; tuning changes instead. Corner inserts use manual length mode. To retain tuning after rounding in those designs, adjust length and compare the calculation again.

Before machining

Hide the top in 3D and inspect both openings. Cutting drawings and DXF describe the base parts before routing, not a finished CNC roundover toolpath. End loading and port losses are estimates; a roundover is not a measured guarantee of a particular reduction in port noise.

Follow the handbook step by step · Download WS TuneLab

Plan your enclosure